4 Operation
Standard equipment
NOTE
The forklift truck can only be driven with the
driver’s seat under load.
¾ Start the engine.
¾ Slightly raise fork arms and tilt lift mast back.
¾ Release the parking brake(1), as appropri-
ate to the version.
Forwards travel
¾ Carefully operate the right acce
lerator pedal
(2).
The driving speed of the truck increases the
further the pedal is pressed down.
NOTE
Pressing down the accelerator pedal hard is
to no advantage as the maximum acceleration
rate is controlled automatically.
Reverse travel
¾ Carefully operate the left accelerator pedal
(4).
The truck will reverse slowly or
quickly de-
pending on the position of the ac
celerator
pedal.
Changing direction of travel
¾ Release accelerator pedal pressed.
The hydrostatic drive will act as a service
brake.
¾ Press the accelerator pedal for t
he opposite
direction of travel.
The forklift truck will now accelerate in the
specified direction.
¾ Both feet should be left on the accelerator
pedals so that the truck is easily controlled
in every driving movement.
The accelerator pedals can be sw
itched over
directly. The hydrostatic driv
e brakes the truck
until it comes to a standstill an
d then acceler-
ates in the opposite direction.
36 Operating Instructions – 393 807 1001 EN – 08/2008
To Next Page
Loading...
