Operation 4
Special equipment
¾ Check the weight adjustment in viewing
window (3).
The correct selection of the driver’s weight has
been made when the arrow (4) is within the
centre clear area of the viewing window.
¾ Adjust as necessary for the drive
r’s weight
• Lift lever (2) upwards (5) = increase weight
setting
• Push lever (2) downwards (6) = decrease
weight setting
Longitudinal adjustment
¾ Lift lever (1) upwards.
¾ Move the driver’s seat on the slide rails
backwards or forwards to give the driver
the best position in relation to the steering
wheel and the accelerator pedals.
¾ Allow lever to click back into place.
Adjust the seat angle
¾ Lift lever 2 and hold it there.
Whilst holding the lever, press on the seat
or release it to move the seat to the desired
position.
Adjust the seat height
¾ Lift lever 1 and hold it there.
Whilst holding the lever, slide t
he seat for-
wards or backwards to move the sea
ttothe
desired position.
Seat heater
NOTE
The maximum temperature is pre-set.
Operating Instructions – 393 807 1001 EN – 08/2008 65
To Next Page
Loading...
