124
6.
Click Apply. The IP Multicast group is added, and the device is updated.
To configure and display the registration of an IP group address, select an address and
click Membership.
The VLAN ID, IP Version, IP Multicast group address, and Source IP address selected are
displayed as read-only in the top of the window. You can select whether to display ports or
LAGs.
7.
For each interface, select its association type.
•
Static—Attaches the interface to the Multicast group as a static member.
•
Dynamic—Indicates that the interface was added to the Multicast group as
a result of IGMP snooping.
•
Forbidden—Specifies that this port is forbidden from joining this group on this
VLAN.
•
Excluded—Indicates that the port is not currently a member of this Multicast
group on this VLAN. This is selected by default until Static or Forbidden is
selected.
8.
Click Apply. The Running Configuration file is updated.
To Next Page
Loading...
