133
•
Next Hop Router IPv6 Address—Address where the packet is forwarded.
Typically, this is the address of a neighboring router. It can be one of the following
types.
o
Link Local—An IPv6 interface and IPv6 address that uniquely identifies
hosts on a single network link. A link local address has a prefix of FE80, is
not routable, and can be used for communication only on the local network.
Only one link local address is supported. If a link local address exists on the
interface, this entry replaces the address in the configuration.
o
Global—An IPv6 address that is a global Unicast IPV6 type that is visible
and reachable from other networks.
o
Point-to-Point—A Point-to-point tunnel.
•
Metric—Value used for comparing this route to other routes with the same
destination in the IPv6 router table. All default routes have the same value.
•
Lifetime—Time period during which the packet can be sent, and resent, before
being deleted.
•
Route Type—How the destination is attached, and the method used to obtain the
entry. The following values are:
•
Local—A directly-connected network whose prefix is derived from a manually-
configured device’s IPv6 address.
o
Dynamic—The destination is an indirectly-attached (remote) IPv6 subnet
address. The entry was obtained dynamically via the ND or ICMP protocol.
IPv6 Neighbors
To Next Page
Loading...
