Linksys LGS326P User Manual

5
Chapter 1 – Getting Started
There are two ways to configure the device: through the graphical user interface and through the
menu command line interface.
Starting the Web-based Configuration Utility
This section describes how to navigate the Web-based switch configuration utility. If you are
using a pop-up blocker, make sure it is disabled. The following browsers are supported:
• Firefox (versions 16 and latest)
• IE version (versions 10 and latest)
• Chrome (versions 35 and latest)
Browser Restrictions
If you are using IPv6 interfaces on your management station, use the IPv6 global address and not
the IPv6 link local address to access the device from your browser.
Launching the Configuration Utility
To open the Web-based configuration utility, do the following:
1. Open a Web browser.
2. Enter the IP address of the device you are configuring in the address bar on the browser,
and then press Enter.
NOTE—When the device is using the factory default IP address of 192.168.1.251, its
power LED flashes continuously. When the device is using a DHCP assigned IP address or
an administrator-configured static IP address, the power LED is on solid.
3. On the login page, enter the username/password.
The password can contain up to 64
ASCII characters. The default username is “admin” and the default password is “admin”.

Linksys LGS326P Specifications

General

Switch type	Managed
Switch layer	-
Quality of Service (QoS) support	Yes
Combo SFP ports quantity	2
Installed SFP+ modules quantity	0
Gigabit Ethernet (copper) ports quantity	26
Basic switching RJ-45 Ethernet ports type	Gigabit Ethernet (10/100/1000)
Basic switching RJ-45 Ethernet ports quantity	24
10G support	No
Number of VLANs	128
Networking standards	IEEE 802.1D, IEEE 802.1p, IEEE 802.1Q, IEEE 802.1s, IEEE 802.1w, IEEE 802.1x, IEEE 802.3, IEEE 802.3ab, IEEE 802.3ad, IEEE 802.3af, IEEE 802.3az, IEEE 802.3u, IEEE 802.3x, IEEE 802.3z
Virtual LAN features	Tagged VLAN
Copper ethernet cabling technology	1000BASE-T, 100BASE-T, 10BASE-T
DHCP features	DHCP client
Security algorithms	802.1x RADIUS
Throughput	38.69 Mpps
Jumbo frames	9000
MAC address table	8000 entries
Product color	Black, Blue
LED indicators	Activity, Link, PoE, System
Number of fans	2 fan(s)
Memory type	DRAM
Internal memory	128 MB
Input current	3.5 A
AC input voltage	100 - 240 V
AC input frequency	50 - 60 Hz
Power consumption (typical)	28.58 W
Total Power over Ethernet (PoE) budget	192 W
Storage temperature (T-T)	-40 - 70 °C
Operating temperature (T-T)	0 - 50 °C
Operating relative humidity (H-H)	10 - 90 %

Weight and Dimensions

Depth	200 mm
Width	440 mm
Height	44 mm
Weight	3096 g