LinMot Step - Set Values through the Serial Interface

LinMot



Design and Installation
User Manual V1.01 4-5
4.1.5 Set values through the serial interface
The following serial hardware interfaces are available:
For standard RS232 serial protocol and commands, please refer to the SW Rel. 1.3
manual
For standard RS485 serial protocol and commands, please refer to the SW Rel. 1.3
manual.
Can Bus interface (Normal CAN version with 11 Bit identifier and Extended CAN
version with 29 Bit identifier) with transfer rates up to 1 Mbaud.
For special applications Sulzer Electronics AG offers the possibility to implement a
specific CAN protocol for the transmission of the set values in the electronic unit.
Sulzer Electronics AG will be happy to give any further information that may be needed
regarding the implementation of specific protocols.
RS232
RS485
CAN BUS