LinMot
Configuration Software
User Manual V1.01 5-23
Save: All the errors listed in the error display can be saved to a file with the extension
“*.err”. This button is only available right after having clicked on the “Show” button.
Show: Two sections are displayed after clicking on the “Show” button of “Actual
Errors”:
The section "ERROR THAT CAUSED TRANSITION TO ERROR STATE" shows
which error caused the transition to the “Error” state.
The section "PENDING ERRORS" lists all the errors active at the moment of reading.
If the “Show” button is clicked when the basis software is not in the “Error” state,
nothing appears in the display window.
Show: Clicking on the "Show" button of "Actual Warnings" causes the actual warnings
to be read and displayed.
The actual errors and warnings can only be displayed when the software on the LinMot
®
electronic unit is started.
Actual errors
Actual warnings
To Next Page
Loading...
