Chapter 3. SCENE
3-1 How to set a SCENE
STEP-1 ：Make sure ”A.” is at ”EDIT MODE”
( The LED of “A.” is dark at ”EDIT MODE”)
STEP-2 ：Select the right format for your LAMP (See chapter 7.)
(“P1…P12” means the On/Off switch of LAMP1…LAMP12 at “EDIT MODE”.
Make sure the LED below the “P1” is bright when setting the LAMP 1.)
STEP-3 ：Use the ”VR” in CH1-CH12 to create a SCENE. (Move the VR up to top and
down to button before adjusting.)
STEP-4 ：Use joystick to adjust. (Move the joystick alongside the edge then adjusting)
STEP-5 ：Use ”FINE” key to adjust in a limited range if necessary.
3-2 How to store a SCENE
STEP-1 ：Press ”PROG” when the desired scene is created
SC
－－－。－－－
Key Number .
STEP-2 ：Key in ”SCENE” number (No. 1…300)，and press ”ENTER”
SC
－－
1
。－－－
EMPTY SCENE LP01
(LCD LINE2
：
will reveal the name of the SCENE，EMPTY SCENE or “LP xx” which
means the last scene you programmed )
STEP-3 ：Use ”1…9” to key in the name of the SCENE
SC
－－
1
。－－－
Press ‘1
－－－
’9 KEY
(Use ”0” (Sel.) KEY to confirm when a character was selected, than key in the following characters
LCD display
To Next Page
Loading...