ISO 9001 CERTIFIED
CX-5 [EUM-B] 13
Chapter 4. CHASE
4-1 How to edit a CHASE
STEP-1 ：Press ”CHASE” ，than ”PROG”
CH
－－－。－－－－－
Keyin Number .
STEP-2 ：Use ‘0…9’ to select a ”CHASE” number (from 1…50)，then press ”ENTER”
CH
－－
1
。
－－－－
EMPTY CHASE
(LCD LINE 2 will reveal the name of the“CHASE”，or “EMPTY CHASE，if the CHASE is
occupied, press ”YES” to overwrite or ”NO” to give up.)
STEP-3 ：Use number key ”1…9” to name the”CHASE”
CH
－－
1
。
AB_
Keyin ENGLISH
(Use ”0” (Sel.) KEY to confirm when a character was selected, than key in the following characters
by the same way.)
STEP-4 ：Press ”ENTER” when a ”CHASE” is named
CH
－－
1
。
CHS
－
0.5Sec
STEP
－－－
1,SCENE
－－
(The vernier is flashing at “STEP 1” )
STEP-5 : Use “ + 4 ” to move the vernier to “SCENE ?” , and key in the “SCENE” number
(from 1…306) that “STEP 1” is corresponding , adjust the “Xfader SPEED” and
“Chase SPEED” (from 0.1 … 25.4 Second)
CH
－－
1
。
CHS
－
0.5Sec
STEP
－－
1,SCENE
－
12
(for example, key in “1” , “2” , means “CHASE 1”
的
“STEP 1 = SCENE 12” )
STEP-6 : Use “w - “ and “ + 4 ” to move vernier , and key in the “SCENE” number you
are going to correspond to.
To Next Page
