ISO 9001 CERTIFIED
CX-5 [EUM-B] 17
4-6 How to insert a STEP into a CHASE
STEP-1 ：Press ”CHASE” then ”PROG”
CH
－－－。－－－－－－－－－－
Keyin Number .
STEP-2 ：Use number key ‘0…9’ to select the ”CHASE” number (from 1…50)，then
press ”ENTER”
(for example, CHASE 2 has the following date :
STEP 1
→
SCENE 4
STEP 2
→
SCENE 3
STEP 3
→
SCENE 2
STEP 4
→
SCENE 1
CH
－－
2
。
－－－－
DEF
(LCD LINE 2 will reveal the name of the “CHASE” , Press ”YES” to overwrite the CHASE if it is
not an empty chase.
STEP-3 ：Use the number key ”1…9” to key in the name of the”CHASE”
CH
－－
2
。
DE_
Keyin ENGLISH
(Use ”0” (Sel.) KEY to confirm when a character was selected, than key in the following characters
by the same way.)
STEP-4 ：Press ”ENTER” when the ”CHASE” is named
CH
－－
2
。
CHS
－
0.5Sec
STEP
－－－
1,SCENE
－－
(now the vernier is flashing at “STEP 1” )
STEP-5 : Move the vernier to the “SCENE” member by “w
-
“ or “ + 4 ” key and key in
the number (from 1…306), Finally press “INS.”, you will see the LED of “YES” , “NO” key is
flashing , press “YES”
CH
－－
2
。
NO,YES
STEP
－－
3,SCENE
－
10
(for example, key in “1” , “0” means to insert SCENE 10 into the STEP 3 of CHASE 2)
To Next Page
