Lite-Puter CX-5 - How to Insert a STEP into a MACRO

ISO 9001 CERTIFIED
CX-5 [EUM-B] 23
5-6 How to insert a STEP to a MACRO
STEP-1 ：Press ”MACRO” then ”PROG”
MA －－－。－－－－
Keyin Number .
STEP-2 ：Use number key ‘0…9’ to select the ”CHASE” number (from 1…50)，then
press ”ENTER” (for example, the CHASE 2 has the following data:
STEP 1 → SCENE 3
STEP 2 → SCENE 2
STEP 3 → CHASE 2
STEP 4 → SCENE 1
MA －－ 2 。 －－－－－
DEF
(LCD LINE 2 will reveal the name of the “MACRO”，press ”YES” to overwite)
STEP-3 ：Use number key ”1…9” to key in the name of the ”MACRO”
MA －－ 2 。 DE_
Keyin ENGLISH
(Use ”0” (Sel.) KEY to confirm when a character was selected, than key in the following characters
by the same way.)
STEP-4 ：Press ”ENTER” when the ”MACRO” is named
MA －－－ 2 。 STEP 1
SC 3.
(now the vernier is flashing at “STEP 1” )
STEP-5 : Use “w - “ or “ + 4 ” to move the vernier to the number of “SC 2”,
MA －－－ 2 。 STEP 2
SC 2 .
STEP-6 : Press “CHASE” ,and key in“3” , then key in the CHASE number (from 1…50) ; and
press “INS.” ., the LED of “YES” , “NO” is flashing, press “YES”
MA －－ 2 。 NO,YES
CH 3 .