ISO 9001 CERTIFIED
CX-5 [EUM-B] 22
MA
－－
1
。
－－－－－
ABC
(LCD LINE 2 will reveal the name of “MACRO”. Press ”YES” to overwrite)
STEP-3 ：Use number key ”1…9” to key in the name of the ”MACRO”
MA
－－
1
。
AB_
Keyin ENGLISH
(Use ”0” (Sel.) KEY to confirm when a character was selected, than key in the following characters
by the same way.)
STEP-4 ：Press ”ENTER” when the ”MACRO” is named
MA
－－－
1
。
STEP 1
SC 1 .
(now the vernier is flashing at “STEP 1” )
STEP-5 : Use “w - “ or “ + 4 ” key to move the vernier to the number of “SC 1"
and press “DEL.” , the LED of “YES” , “NO” LED is flashing. Press “YES” to delete.
MA
－－
1
。
NO,YES
SC 1 .
STEP-6 : The date SCENE 1 in CHASE STEP 1 is deleted after “YES” key is pressed.
(for example, move the vernier to the number of “SC _” at CHASE STEP 1 then press “YES”
key to delete SCENE 1 from CHASE STEP 1 .)
STEP-7 : use “w - “ or “ + 4 ” key to move the vernier to revise MACRO STEP .
MA
－－－
1
。
STEP 5
CH 3 .
(for example, use “w - “ or “ + 4
” to increase up to MACRO STEP 5)
STEP-8 : Make sure the vernier has been moved to very end of LCD Line 2 , press “ENTER”
to store the date :
MACRO 1 : (There are 5 STEP)
STEP 1
→
CHASE 1 ( SCENE 1 is deleted and replaced by CHASE 1)
STEP 2
→
SCENE 2
STEP 3
→
CHASE 2
STEP 4
→
SCENE 3
STEP 5
→
CHASE 3
To Next Page
