ISO 9001 CERTIFIED
CX-5 [EUM-B] 20
STEP-6 : Use “w - “ “ + 4 ” key to move the vernier , and key in the corresponding
“SCENE” or "CHASE” number step by step. .
STEP-7 : Finally, move the vernier to the second line of the LCD “SC _”(or “CH _”) ,
then press “ENTER” to finished and stored the edit of “MACRO”.
5-2 How to load a MACRO
STEP-1 ：Press ”MACRO” , and key in the number of ”MACRO” (from 1…50)
MACRO 1 ‘GO’
AA
(LCD LINE2 will reveal the name of the ”MCARO” )
STEP-2 ：Press ”GO” to load the ”MACRO 1”
5-3 How to load a MACRO by ”P1…P12”(HOT KEY)
STEP-1 ：Press “MACRO” and make sure you are in “MACRO”
STEP-2 ：Press ”A.”，make sure you are at ”RUN MODE“
(The LED of “A..” is bright)
STEP-3 ：Press ”P1…P12” to load the MACRO .
(A previous setting by manufacturer: P1= MACRO 1 ….. P12= MACRO 12)
User may use “FNC” + “2” (FAVORITE MACRO) to reset .
5-4 How to correspond the date
of MACRO 1… 50 to “P1…P12”(HOT KEY)
STEP-1 : Press ”MACRO”，and make sure you are in”MACRO“
STEP-2 : Press ”FNC.”
FUNCTION
To Next Page
Loading...