Lite-Puter CX-5 - Call out the Pattern Built in the Program by the Use of Number Buttons under the Function SCENE; Call out the Pattern Built in the Program by the Use of Hot Key P1

ISO 9001 CERTIFIED
CX-5 [EUM-B] 36
Users have pressed “ + 4”, so the SCENE
memories change to SCENE 303.
STEP-8 Pressing “ENTER” when all the “pattern”､the “center” and the “speed” are decided,
then the data of the pattern will be saved in SCENE 303.
(SCENE 301~SCENE 306 cannot control different types of scanners at one time.)
10-3 Call out the pattern built in the program by the
use of number buttons under the function SCENE”
STEP-1 After saving the pattern built in the program in SCENE 301~ 306, users can press the
button “SCENE” and enter the function “SCENE”.
STEP-2 Press “3”､“0”､“1” and “GO” to call out the pattern saved in SCENE 301.
STEP-3 Press “3”､“0”､“6” and “GO” to call out the pattern saved in SCENE 306 .
10-4 Call out the pattern built in the program by the use
of hot key “P1~P12” under the function “SCENE”
STEP-1 Press “SCENE” to enter the function “SCENE” .
STEP-2 Press “FNC” + “982” to enter the edit model “FAVORITE SCENE”.
STEP-3 Set up P1~P12 according to the description in Chapter 2-6 and save them in the
memory.
P1=SCENE 306
P2=SCENE 305
P3=SCENE 304
P4=SCENE 1
P5=SCENE 302
:
GRAPHIC FUNCTION
PROGRAM SC 303
FAVORITE SCENE
P1 = SCENE