STEP-3 : Press ” YES” , the SCENE is deleted
3-7 How to load a SCENE by ”P1…P12”(HOT KEY)
STEP-1 ：Press “SCENE” and make sure the LED of SCENE is bright.
STEP-2 ：Press ”A.”，make sure you are at ”RUN MODE“
( the LED of “A..” is bright)
STEP-3 ：Press ”P1…P12” for a speedy load of a SCENE .
(A previous setting of manufacturer: P1= SCENE 1 ….. P12= SCENE 12,
Use “FNC” + “2” (FAVORITE SCENE) to change the setting f“P1…P12”)
3-8 How to correspond
SCENE 1…306 to “P1…P12” (HOT KEY )
STEP-1 : Press “SCENE” and make sure the LED of SCENE is bright.
STEP-2 : Press ”FNC.”
FUNCTION:
Keyin Number
(‘FNC’ + ‘981 … 9 ‘ See Chapter 12 for the table of FNC KEY.)
STEP-3 : Press number key ”982”
FAVORITE SCENE
P 1 = SCENE 1
( LCD vernier flashing at “P 1”)
STEP-4 : Use “ + 4 ” to mover the vernier to “SCENE 1” , and key in the SCENE number
You are going to correspond to “P 1” (from 1…306)
To Next Page
Loading...
