ISO 9001 CERTIFIED
CX-5 [EUM-B] 14
STEP-7 : Move the vernier to “SCENE” , and press “ENTER” key to store the “CHASE” and
stop editing.
4-2 How to load a CHASE
STEP-1 ：Press ”CHASE” , and key in ”CHASE” number (from 1…50)
CH
－－
1
。
GO
A
(LCD LINE2 will reveal the name of the ”CHASE” )
STEP-2 ：Press ”GO” to load the ”CHASE 1”
4-3 How to load a CHASE by “P1…P12”(HOT KEY)
STEP-1 ：Press “CHASE” and make sure the LED of CHASE is bright .
STEP-2 ：Press ”A.”，and make sure you are at ”RUN MODE“
(The LED of “A..” is bright)
STEP-3 ：Press ”P1…P12” for speed load of a CHASE .
(A previous setting by manufacturer: P1= CHASE 1 ….. P12= CHASE 12)
User can change the setting by press “FNC” + “2” (FAVORITE CHASE)
4-4 How to correspond
the CHASE 1…50 to “P1…P12”(HOT KEY)
STEP-1 : Press ”CHASE” and make sure the LED of ”CHASE“ is bright
STEP-2 : Press ”FNC.”
FUNCTION
Keyin Number
(‘FNC’ + ‘981 …9 ‘ Please see Chapter 12.)
STEP-3 : Press number key ”982”
To Next Page
