Lite-Puter CX-5 - Chapter 5. MACRO; How to Edit and Store a MACRO

ISO 9001 CERTIFIED
CX-5 [EUM-B] 19
Chapter 5. MACRO
5-1 How to edit and store a MACRO
STEP-1 ：Press ”MACRO” and then ”PROG”
MA －－－。－－－－
Keyin Number .
STEP-2 ：Use number key ‘0…9’ to select the ”MACRO” number (from 1…50)，then
press ”ENTER”
MA －－ 1 。 －－－－－
EMPTY MACRO
(LCD LINE 2 will reveal the name of “MACRO”, or EMPTY MACRO，
Press ”YES” to overwrite the date if it is not an empty CHASE)
STEP-3 ：Key in the name of the”MACRO” by number key ”1…9”
MA －－ 1 。 AB_
Keyin ENGLISH
(Use ”0” (Sel.) KEY to confirm when a character was selected, than key in the following characters
by the same way.)
STEP-4 ：Press”ENTER” when the ”MACRO” is named
MA －－ 1 。 STEP 1
SC .
(the vernier is flashing at “STEP 1”)
STEP-5: Move the vernier to “SC ” by “ + 4 ” key. ( “SC _” , means MACRO STEP 1,
you can define any date of SCENE 1…306). You may press “CHASE” key
which means to define CHASE 1…50 as MACRO STEP 1.
MA －－－ 1 。 STEP 1
CH 2.
(for example, press “CHASE”,
then key in “2” , means “MACRO 1” “STEP 1 = CHASE 2” )
LCD display:
“SC “ means “SCENE”
“CH “ means “CHASE”.