Lite-Puter CX-5 - How to Set Xfader Speed in a LEARN

ISO 9001 CERTIFIED
CX-5 [EUM-B] 28
(for example, key in “1” , “2” means “P1 = LEARN 12”)
STEP-5 : Use “w - “ or “ + 4 ” to move the vernier to corresponding “LEARN” step by
step.
STEP-6 : Finally move the vernier to “LEARN” , and press “ENTER” to finish.
6-5 How to set Xfader SPEED in a LEARN
STEP-1 : Press ”FNC.”
FUNCTION
KEYIN Number
(‘FNC’ + ‘ 981 … 9 ‘ Please read Chapter 12)
STEP-2 : Press number ”3”
LEARN Xfader < >
XFD SPD = 0.2 SEC ‘
STEP-3 : Press ” w - “ or “ + 4” , LCD will reveal “XFD SPD = 0.2 SEC” or
“XFD SPD = CHS SPD”
STEP-4 : Press ”ENTER” to finish the setting of LEARN Xfader.
(XFD SPD = 0.2 SEC means Xfadre SPEED = 0.2 SECOND
XFD SPD = CHS PSD means Xfadre SPEED =Chase SPEED)