ISO 9001 CERTIFIED
CX-5 [EUM-B] 39
Chapter 12 Foresee of FNC Key
“FNC” + “981” → The function to set up the manufacturers and types of scanner.
“FNC” + “982” → The setting up of P1…..P12 (HOT KEY) is as below:
Under “SCENE”: “P1...P12” can correspond to any data in
“SCENE1…306”
Under “CHASE”: “P1…P12” can correspond to any data in
“CHASE1…50”
Under “MACRO”: “P1....P12” can correspond to any data in
"MACRO1…50”
Under “LEARN”: “P1….P12” can correspond to any data in
“LEARN1…50”
“FNC” + “983” → Set upXfader SPEED of the function “LEARN” as 0.2 SECOND or
CHASE SPEED.
“FNC” + “984” → Use “w - ” & “
+
4“ to select 4 different kinds of pattern.
“FNC” + “985” → Set up 24 sets of MIDI MEMORY ( please refer to Chapter 9-3 )
(1) Each of the 128 different MIDI NOTE NUMBER is correspond to
24 different sets of MIDI MEMORY
(please refer to Chapter 9-1 –Corresponding Table of MIDI
NOTE NUMBER & MIDI MEMORY In CX-5).
(2) Each set of MIDI MEMORY can correspond to any one of
SCENE 1…306”.
(3) After MIDI MEMORY are set as SCENE 1~306, users can call out
24 different SCENE by MIDI KEY.
“FNC” + “986” → Set up MIDI CHANNEL of CX-5.(please refer to Chapter9-2)
(1) Outside MIDI interface can set up 16 different CHANNEL (1~16).
(2) The value of CHANNEL inside CX-5 has to correspond to thoseof the
MIDI interface , so that CX-5 can receive the MIDI signal from
MIDI interface.
To Next Page
Loading...
