ISO 9001 CERTIFIED
CX-5 [EUM-B] 16
STEP-3 ：Use number key ”1…9” to key in the name of the”CHASE”
CH
－－
1
。
AB_
Keyin ENGLISH
(Use ”0” (Sel.) KEY to confirm when a character was selected, than key in the following characters
by the same way.)
STEP-4 ：Press ”ENTER” when the ”CHASE” is named
CH
－－
1
。
CHS
－
0.5Sec
STEP
－－－
1,SCENE
－－－
(The vernier is flashing at “STEP 1” )
STEP-5 : Use “w - “ and “ + 4 ” to move the vernier to the “SCENE” number you are
going to delete, and press “DEL.” , not the LED of “YES” and “NO” is flashing,
press “YES” to confirm..
CH
－－
1
。
NO,YES
STEP
－－
2, SCENE
－－
2
STEP-6 : The SCENE 2 in CHASE STEP 2 has been deleted after “YES” key is pressed.
STEP-7 : Use “w - “ or “ + 4 ” to move the vernier to the last STEP (SCENE number) of
the CHASE STEP .
CH
－－
1
。
CHS
－
0.5Sec
STEP
－－
5,SCENE
－－
6
STEP-8 : Make sure the vernier has been moved to the “SCENE” number and press "ENTER” to
store the date.
CHASE 1 : (There are 5 STEP)
STEP 1
→
SCENE 1
STEP 2
→
SCENE 3 ( SCENE 2 is deleted and replaced by SCENE 3 )
STEP 3
→
SCENE 4
STEP 4
→
SCENE 5
STEP 5
→
SCENE 6
To Next Page
