Lite-Puter CX-5 - Page 3

ISO 9001 CERTIFIED
CX-5 [EUM-B]
2
6-1 How to edit and store a LEARN ............................................................... 25
6-2 How to load a LEARN ............................................................................. 26
6-3 How to correspond LEARN 1…50 to "P1…P12”(HOT KEY) ................ 26
6-4 How to load a LEARN by "P1…P12" (HOT KEY) ................................ 27
6-5 How to set Xfader speed in a LEARN....................................................... 28
Chapter 7. BLACK 、 FINE
BLACK............................................................................................................. 29
FINE.................................................................................................................. 29
Chapter 8. How to select the start address
............................................................................................................................30
Chapter 9. MIDI
9-1 Introduction of MIDI................................................................................. 31
9-2 Set up MIDI channel of CX-5................................................................... 32
9-3 How to store 24 different "SCENE" in MIDI memory................................ 33
Chapter 10. How to call out pattern built in the program
10-1 Explanation of the pattern built in the program............................................ 34
10-2 Preview the pattern built in the program, and save it to any
one of SCENE 301 ~ 306.................................................................... 35
10-3 Call out the pattern built in the program by the use of number
buttons under the function SCENE ......................................................... 36
10-4 Call out the pattern built in the program by the use of hot key
"P1…P12" under the function "SCENE" ................................................ 36
Chapter 11. Main lamp setting
11-1 How to setting main lamp......................................................................... 38
Chapter 12. Foresee of FNC Key
............................................................................................................................39
Chapter 13. Appendix
Appendix-1 How to make a "SCENE"............................................................. 41
Appendix-2 Call out the saved scene to amend any of the channels. .................. 42
Appendix-3 When you use P1…P12 to choose the light
you want to control..................................................................... 42