LiteOn EVO 6800 Series - Page 202

202
Parameter
Name
Description
Unit
Multi-Function Terminal Output (terminal R2A –R2C)
Multi-Function Photocoupler Output 1 (terminal D1)
Multi-Function Photocoupler Output 2 (terminal D2)
U1-11
Drive Operation
Status
Displays the status of the drive operation.
U1-11=11111111
The following indicate each digit from right to left.
1:During Run
1:During Zero Speed Holding
1:During Reverse
1:During Fault Reset Signal Input
1:During Speed Agree
1:Drive Ready
1:During Alarm Detection
1:During Fault Detection
-
U1-12
Terminal A1 Input
Voltage
Displays the terminal A1 input voltage.
0.1%
U1-13
Terminal A2 Input
Voltage
Displays the terminal A2 input voltage.
0.1%
U1-14
Output Frequency
after Soft Starter
Displays output frequency with ramp time and S-curves.
0.01 Hz
U1-15
Input Pulse Monitor
Displays the frequency to pulse input.
1Hz
U1-16
Software Version
Displays the software version.
-
U2: Fault Information
U2-00
Current Fault
Displays the current fault.
-
U2-01
1
st
Most Recent Fault
Displays the first most recent fault.
-
U2-02
2
nd
Most Recent
Fault
Displays the second most recent fault.
-
U2-03
3
rd
Most Recent Fault
Displays the third most recent fault.
-
U2-04
4
th
Most Recent Fault
Displays the fourth most recent fault.
-
U2-05
Frequency
Command at 1
st
Most Recent Fault
Displays the frequency command at the first most recent
fault.
-
U2-06
Output Frequency at
1
st
Most Recent Fault
Displays the output frequency at the first most recent fault.
-
U2-07
Output Current at 1
st
Displays the output current at the first most recent fault.
0.01A