LiteOn EVO 6800 Series - E4 Multi-Function Analog Output

157
Sets the differential PID feedback by the analog input value. The difference of the PID feedback
input value and the differential feedback input value is used to calculate the PID input.
11 : Overtorque/ Undertorque Detection
Sets the detection level for overtorque and undertorque by the analog input value. Use the
combination of this function and P6-00 (Overtorque/ Undertorque Detection Selection 1). This
is the secondary source for P6-01 (Overtorque/ Undertorque Detection Level 1). When the
input is 100% (10 V, 20 mA), the motor rated torque will be 100%. Refer to P6 (Overtorque/
Undertorque Detection) for details.
18/19 : Communication Mode
If the terminal is assigned to 18 or 19, ther input signal can be used as an analog input from
the upper controller via Modbus.
E4 Multi-Function Analog Output
These parameters assign functions to terminal FM and AM to monitor the status of the drive.
 E4-00 Terminal FM Signal Level Selection
Sets the signal level to terminal FM using E4-01.
No.
Name
Setting Range
Default
E4-00
Terminal FM Signal Level Selection
0, 1
0
0 : 0 to 10 V
1 : - 10 V to 10 V
 E4-04 Terminal AM Signal Level Selection
Selects the signal level to terminal AM.
No.
Name
Setting Range
Default
E4-04
Terminal AM Signal Level Selection
0, 1, 2
0
0: 0 to 10 V
1: 0 to 20 mA
2: 4 to 20 mA
 E4-01 / E4-05 Terminal FM and AM Monitor Selection
Selects the monitor for terminal FM and AM.
No.
Name
Setting Range
Default
E4-01
Terminal FM Monitor Selection
0 to 11
1
E4-05
Terminal AM Monitor Selection
0 to 11
2