LiteOn EVO 6800 Series - Group E, Multi-Function Terminals; E1 Multi-Function Digital Inputs

127
6.6 Group E, Multi-Function Terminals
E1 Multi-Function Digital Inputs
 E1- 00 to E1- 07 Terminal S1 to S7 Function Selection
Assigns functions to multi-function terminals S1 to S7. Set this parameter according to Table
6.18.
No.
Name
Setting Range
Default
E1-00
Terminal S1 Function
Selection
0～74 / 100~174
0 : 2-Wire Sequence Control (Forward/Stop)
E1-01
Terminal S2 Function
Selection
0～74 / 100~174
1: 2-Wire Sequence Control (Forward/Stop)
E1-02
Terminal S3 Function
Selection
0～74 / 100~174
23 : External Fault
E1-03
Terminal S4 Function
Selection
0～74 / 100~174
39: Fault Reset
E1-04
Terminal S5 Function
Selection
0～74 / 100~174
5: Multi-Step Speed Command 1
E1-05
Terminal S6 Function
Selection
0～74 / 100~174
6: Multi-Step Speed Command 2
E1-06
Terminal S7 Function
Selection
0～74 / 100~174
9: Jog Frequency
Note1. Digital input terminals if necessary reverse input function, parameter settings can be selected for
its hundreds digit 1 can be realized
EX: Forward / stop selection for the N、C mode, the parameter can be set to 100.
Note2. Parameters option contains 2、23 to 38,select N、C modes
Table 6.18
Setting
Functions
Setting
Functions
0
2-Wire Sequence Control
(Forward/Stop)
41
Multi-Function Analog Input Selection
(Terminal A1 and A2)
1
2-Wire Sequence Control
(Reverse/Stop)
42
Retain
2
3-Wire Sequence
43
Retain
3
Local/Remote Selection
44
Retain
4
Command Source 1/2 Selection
45
Communication Mode
5
Multi-Step Speed Command 1
46
PID Disable
6
Multi-Step Speed Command 2
47
PID Integral Reset