LiteOn EVO 6800 Series - Page 39

39
even lower level.
 Removing the jumper may increase the signal interference
.
4.2.2.6 Ring Terminal
 Main circuit terminal should be used with crimp ring terminal wiring，
 Please refer to the diagram about ring terminal size, where the 8 AWG and 10 AWG bare
recommend using W size must be less than 10.5 mm, d2 size must be greater than 5.0
 Ring terminal shall be insulated cover of the terminal block wiring, which can form a reference KST
RVBS8-5 & KST RVB5-5 or similar size ring terminals to facilitate wiring and other operations
Diameter
Terminal Type
Terminal Specifications
W
d2
d1
D
F
E
L
T
AWG 8
RVBS8-5
8.8
5.3
4.5
8.5
10.5
16.7
31.6
1.2
AWG 10
RVB5-5
9.5
5.3
3.4
6.4
8.3
13
26
1