Start-up
Using the remote control for the first time
To insert or change the batteries, press on the arrow. While doing so, simply slide
the battery compartment lid down and remove it. Insert alkali manganese bat-
teries LR 03 (AAA) and ensure the correct position of + and –. Slide the cover on
again from the bottom.
Setting up the Assist Remote Control
Other Devices
You can operate various Loewe devices using the Assist Remote Control. The device
buttons REC - BD - AUDIO can be set up for this.
Press the required device buttons and the Stop button
simultaneously for 5 sec. until the corresponding LED display
flashes twice.
Then select the two-digit device code from the table:
Unit Code Restore defaults
Loewe ViewVision 8106 H 10
Loewe ViewVision, Centros 21x2 12
Loewe ViewVision DR+ DVB-T 13 REC
Loewe Auro 2216 PS/8116 DT 14
Loewe BlutechVision 15
Loewe Sound Projector 1 17
Loewe TV Radio digital 19
Loewe Mediacenter 20 AUDIO
Loewe BlutechVision Interactive 21 BD
HDMI CEC Mode ¾¾
22
Loewe AudioVision 24
Loewe Sound Projector SL 25
Restore defaults 99
The corresponding LED Display flashes twice.
Sound functions
It is possible to set the devices with which the buttons with the sound functions
(V+/-, Mute and sound mode) should work. Depending upon which device con-
figuration you use (page 13- page 15), set the device keys and sound functions
of the Assist remote control. If you use the integrated network configuration as
described on page 13, the Loewe TV set will process the sound and the sound
functions of the Assist remote control do not have to be changed. With a configu-
ration as described on page 14 and page 15, it is necessary to change the sound
functions on the Assist remote control as described below.
Press the device button TV and at the same time the button
with the single digit function code from the list for 5 sec. until
the LED Display flashes twice.
Function Code Figure
Loewe AudioVision 3
Loewe Mediacenter 4 Page 15
Loewe TV ¾
5 Page 13 / Page 14
Loewe Sound Projector 6
¾ Restore defaults
¾¾ From mainframe L271x, Software V9.16
Operating Loewe Equipment
Using the remote control for a Loewe TV set
Press TV button; the LED Display above it
lights up for approx. 5 seconds
Using the remote control for a Loewe recorder
Press the REC button; the LED Display above
it lights up for approx. 5 seconds
Using the remote control for BluTechVision Interactive
Press the BD button; the LED Display above
it lights up for approx. 5 seconds
Using the remote control for Mediacenter
Press the AUDIO button; the LED Display above
it lights up for approx. 5 seconds
Every time a button is pressed, the LED display lights up for the selected operating
mode for checking purposes (TV – REC – BD – AUDIO).
Please refer to the respective operating conditions on how to operate the indi-
vidual devices.
- 16
To Next Page
Loading...