90
3. To use the default sonar chart log stored in the unit, press ↓ to
CHART
USED | DEMO SONAR CHART.BLG | ENT | EXIT| EXIT | EXIT. The recorded chart
begins scrolling across the screen, just as if you were on the water.
4. Turn off the Sonar Simulator by pressing
MENU|MENU|↓ to SYSTEM
SETUP|ENT|↓ to SIMULATORS|ENT|↓ to SIMULATORS| ENT|→ to SONAR SIMULATOR|↓
SONAR SIMULATOR ON | ENT | EXIT | EXIT | EXIT.
.
The Sonar Page playing a recorded sonar chart in Simulator mode.
Tip:
The Sonar Simulator can use sonar charts recorded (logged) on a MMC
card (To see how, read the entry in this section on Log Sonar Chart Data).
To play back a sonar chart, make sure the MMC containing the chart is
installed, then:
1. Press
MENU|MENU|↓ to SONAR SETUP|ENT|↓ to SONAR SIMULATOR|ENT.
2. Press ↓ to
CHART USED|ENT.
3. Use ↓ or ↑ to select chart name|
ENT|↑ to SONAR SIMULATOR ON|ENT|EXIT.
While you're in the Sonar Simulator menu, don't forget to check Simulate
Position if you want to run the sonar and GPS simulators simultaneously.
As you review sonar logs, you can create waypoints to mark sites you
want revisit.
While the simulator is running, you can switch from one chart log to
another by opening the Sonar Simulator menu and using the instructions
in step 2 to select a different chart.
NOTE:
If you turn on your unit before attaching a transducer, it may enter a
demo mode. The words "demo mode" flash on the bottom of the screen and
a sonar chart plays much like the simulator. Unlike the simulator, the
demo mode is for demonstration only, and will automatically stop as soon
as you turn on the unit with a transducer attached. The simulator will
continue to function normally.
"Play"
symbol
flashing
Title bar
with chart
file name
To Next Page
Loading...
Need help?
General
