124
Navigate a Trail (forward)
The following figures illustrate the menu sequence for navigating a trail.
1. Press
MENU|MENU|↓ to MY TRAILS|ENT.
2. Press ↓ to enter the Saved Trail list, then use ↑ or ↓ to select the desired
Trail Name|
ENT.
3. Press → to
DELETE TRAIL|↓ to NAVIGATE|ENT.
4. Press ↓ to
NAVIGATE|ENT.
NOTE:
If you are already located at or near the beginning of your trail, the
arrival alarm will go off as soon as you hit
ENT. Press EXIT to clear
the alarm and proceed.
5. Now, begin moving and let your unit guide you.
6. When you reach your destination, be sure to cancel your navigation:
press
MENU|MENU|↓ to CANCEL NAVIGATION|ENT. The unit asks if you're
sure, press
←|ENT.
Navigate a trail menu sequence: Fig. 1, My Trails command. Fig. 2, Trails
Menu. Fig. 3, Edit Trail Menu. Fig. 4, Edit Route Menu with Navigate
command highlighted for Trail 6. A trail is always converted to a "route"
when you navigate the trail.
Figure 3.
Figure 4.
Figure 1.
Figure 2.
To Next Page
Loading...
Need help?
General
