194
7. Highlight
SET CONFIGURATION and press ENT to finalize alarm settings.
Press
EXIT repeatedly to get back to the main display.
NOTE:
To turn off (uncheck) an alarm, highlight its ENABLED BOX and press
ENTER.
Waypoint Sharing
Waypoint Sharing allows you to share a waypoint from one display unit
with display units across the network.
To turn on/off Waypoint Sharing:
1. Press
MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight
WAYPOINT SHARING and press ENT which will turn on/off
waypoint sharing.
3. Press
EXIT repeatedly to get return to the main display.
Backlight Synchronization
The Backlight Synchronization command will keep all display unit
backlight levels consistent across the NMEA 2000 network. So, if you
set the backlight level to 75% on one display unit, all other units on the
network will automatically switch to the same setting.
To turn on/off Backlight Synchronization:
1. Press MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight
BACKLIGHT SYNCHRONIZATION and press ENT, which will turn
on/off Backlight Synchronization.
3. Press
EXIT repeatedly to get back to the main display.
Configuring EP Sensors
All configurable devices are configured through their Device Configuration
menus, which may be accessed through the network devices list on the Bus
Configuration menu.
EP-35 Temperature Configuration
To input Device Name:
1. Press MENU|MENU, use ↑ ↓ to select NMEA 2000 and press ENT. The
NMEA 2000 menu will appear with five options: Bus Setup, Fuel
Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization.
2. Highlight BUS SETUP and press ENT, which will open the Bus Configuration
menu. A list of network devices will be at the top of the page.
3. Select the temp sensor you want to rename and press
ENT. The
Device Configuration menu will appear with the Device Name dialog
box highlighted.
To Next Page
Loading...
Need help?
General
