192
1. Press
MENU|MENU, select NMEA 2000 and press ENT.
2. The NMEA 2000 menu will appear with five options: Bus Setup, Fuel
Management, NMEA 2000 Alarms, Waypoint Sharing and Backlight
Synchronization. Select
FUEL MANAGEMENT and press ENT.
3. Highlight
TANK LOCATION and press ENT. The Tank Location menu will
appear with up to three options: Port, Center and Starboard.
4. Select the tank you added fuel to and press
ENT.
5. Follow the steps below that apply to your tank.
If you filled up the tank:
A. Press the
FILL TANK button and press ENT. The following message will
appear: Are you sure you wish to Fill Tank? Press
ENT. Another message will
appear: Do you wish to re-calibrate the device? Highlight
NO and press ENT.
If you did not fill up the tank:
B. Highlight FUEL ADDED and press ENT to access the FUEL ADDED dialog
box. Use ↑ ↓ , ← → to input the amount of fuel added to the tank and
press
ENT. Select the ADD FUEL button and press ENT. The following
message will appear: Are you sure you wish to Add Fuel? Highlight
YES
and press
ENT.
6. Press
EXIT repeatedly to get back to the main display.
Engine Operations
The lower half of the Fuel Management menu contains the following
Engine Operation functions: Engine Select, Reset Calibration, Reset Trip
and Reset Seasonal.
Engine Select
Engine Select allows you to choose the desired engine when resetting
calibration, resetting trip fuel and resetting seasonal fuel.
To Reset Calibration:
Choosing the Reset Calibration command will switch fuel flow calibration
settings back to factory defaults.
1. Press
MENU|MENU, select NMEA 2000 and press ENT.
2. Highlight
FUEL MANAGEMENT and press ENT. The Fuel Management
menu will appear.
3. Highlight to
ENGINE SELECT and press ENT. Select the desired engine —
the engine attached to the desired fuel flow — and press
ENT.
4. Highlight
RESET CALIBRATION and press ENT. The following confirmation
message will appear: Are you sure you wish to Reset Calibration? Select
YES and press ENT. Calibration settings for the selected fuel have been
returned to factory defaults.
To Next Page
Loading...
Need help?
General
