186
A. To navigate to the waypoint, press ENT (The Go To Waypoint
command is already highlighted.). The unit will show navigation
information to the waypoint.
B. To find the waypoint, press ↓ to FIND ON MAP|ENT. The Map Page
appears with the cursor highlighting the found waypoint.
Waypoint Information screens with the Go To Waypoint command
selected (left) and the Find on Map command selected (right).
To clear these menus and return to the previous page, press EXIT
repeatedly.
5. If you're looking by name, there are two options: A. You can spell out
the name in the top selection box. Press
↑ or ↓ to change the first letter,
then press → to move the cursor to the next letter and repeat until the
name is correct
, then press ENT|ENT. B. Or you can jump down to the
lower selection list by pressing
ENT, then use ↓ or ↑ to select a waypoint
from the list, then press
ENT. The waypoint information screen appears.
Find By Name menu (left); Waypoint Information screen (center); The
found waypoint is highlighted by the cursor on the Map Page (right).
A. To navigate
to the waypoint, press ENT (Go To Waypoint command
is already highlighted.). The unit will show navigation information
to the waypoint
.
B. To find
the waypoint, press ↓ to FIND|ENT. The Map Page appears
with the cursor highlighting the found waypoint.
To clear these menus and return to the previous page, press EXIT
repeatedly.
To Next Page
Loading...
Need help?
General
