LSIS XGL-EFMTB - Page 100

Chapter 6 High-speed Link Service
6-18
6.7 High Speed Link Setting Program Example
6.7.1 In case of redundant system
(1) In case XGR is transmission mode and XGK(I) is reception mode
1) Communication setting (XGR transmission side)
a) Stand parameter setting (When One IP Solution is used and same HS link station number is
applied)
[Fig 6.7.1] Communication redundant standard setting
b) HS link block setting (In case sequence number is saved in Block 0)
[Fig 6.7.2] HS link block setting including sequence
c) HS link block setting (In case of setting sequence number (First Word) and user data in Block 0)
[Fig 6.7.3] HS link block setting not including sequence
2) Ladder program (XGR reception side)
a) Increase the sequence number in the first Block and set the data to send in the second Block