Chapter 1 Overview
1-7
1.4.2 XG5000
XG5000 is exclusive software to setup parameters, edit frames and diagnose communication
modules of XGT series PLC and network necessary for operation of all the communication
modules including FEnet I/F module.
Refer to Chapter 5 XG5000 for more details.
The figure below shows the initial screen of XG5000.
[Fig. 1.4.1] Initial screen of XG5000
1.4.3 Version checking
Prior to use of FEnet I/F module, please check the version of the applicable module.
(1) Through XG5000
Connect with communication module directly via on-line so to read information of the
communication module.
If interface status with CPU is normal, the information will be acquired as shown below.
a) Execute XG5000.
b) Use on-line connection with CPU.
c) If connection between XG5000 and CPU is established, execute diagnosis of XG5000.
d) On the system diagnosis screen, execute communication module status.
e) Software information will be displayed on the right bottom of the communication module
status screen.
To Next Page
Loading...