Chapter 7 P2P Service
7-9
7.3.3 P2P Block
If user select P2P block of relevant parameter, P2P parameter setting window will be displayed.
[Table 7.3.5] selection of P2P block
Up to 64 independent blocks are available. If user selects some block at XG5000, user can set the
function of block.
[Fig 7.3.6] P2P instruction
Each item is as follows
(1) E-mail
Used for E-mail service
(2) Channel
Select a communication port which will be used by the applicable block.
The communication port for each block is decided when P2P Channel is setup, which can
not be changed during Run.
(3) Driver Setting
Indicates communication driver set in P2P setting. When setting channel, driver
is loaded automatically according to channel. If it is deleted at P2P channel
setting, driver will be deleted automatically. For more detail, refer to CH7.3.2 P2P
channel.
To Next Page
Loading...