LSIS XGL-EFMTB - Abnormal Operation Display XGL-EH5 T

Chapter 10 Troubleshooting
10-4
10.1.3
Abnormal operation display of XGL-EH5T
The operation status can be checked through LED in front of Ethernet module
<XGL-EH5T’s LED>
[Fig 10.1.3] LED structure of FEnet I/F module
This switch module (EH5T) doesn’t need specific parameter setting and it uses power
form Base. After turning on, if all LEDs except power LED flicker one time, switch module
is normal.
LED Error Action
PWR
LED off after
power on
1) Abnormal equipment of switch module
- Check DC 5V power supply of power module.
- check the communication module if correctly installed on
the base.
ACT ACT LED off
1) Check if cable is connected to port correctly.
LED is off in the disconnection status
2) Check if data is communicated normally
LNK LNK LED off
1) Check if cable is connected to port correctly.
LED is off in the disconnection status