LSIS XGL-EFMTB - Product Configuration; Designation; Vailable Units to be Installed on each CPU

Chapter 1 Introduction
1-4
1.3 Product Configuration
1.3.1 Designation
Product configuration of XGT FEnet I/F module is as follows;
Designations Description Remarks
XGK/XGI/XGR
XGL-EFMT 10BASE-T/100BASE-TX Category 5 or more(STP)
XGL-EFMTB 100BASE-TX/1000BASE-T Category 5 or more(STP)
XGL-EFMF
100BASE-FX
Fiber Optic (SC)
XGL-EFMFB
100BASE-FX/1000X
Fiber Optic(LC/SFP)
XGL-EH5T 10/100BASE-TX Switch
Notes
1) AUI (10BASE-5) is not supported in XGT series.
2) In the case that UTP cable is used, use the switching hub of 100Mbps
, which can be used
together with the 10Mbps Ethernet device (category 3 or less) but its baud rate will be limited to
10Mbps.
Pay attention to installation of the system.
3) XGL-EH5T can be installed on XGT base and used as switch without specific program. It has
maximum 100Mbps speed
1.3.2 Available units to be installed on each CPU
The maximum installation number of modules based on CPU type of each FEnet I/F module is
described in the table below. After due consideration of the number of communication modules
available, apply such applicable modules to the system configuration.
Segment
XGK
XGI
XGR
CPUH
CPUU CPUA
CPUS
CPUE
CPUSN
CPUHN
CPUUN
CPUU
CPUH
CPUS CPUE
CPUU/
D
CPUU
N
CPUH
/T
CPUH
/F
CPUH
/S
Number of HS
Link use
module(Maximu
m)
12 units 6 units
Number of P2P
use
modules(maximu
m)
8 units 6 units
Maximum
number of
modules(server
use modules
included)
24 units 6 units