LSIS XGL-EFMTB - How to Install or Remove the Module

Chapter 3 Installation and Test Operation
3-10
3.3.3 How to install or remove the module
Follow the steps described below to replace or remove the applicable module due to its
hardware error or system change.
(1) To replace the communication module
(1) Power off the base where the communication module is installed on.
(2) Disconnect the network cable.
(3) Install a new module as specified in the steps of 3.3.2 above.
(2) Replacement by the module change switch of CPU
Refer to how to use the module exchange switch of CPU
(3) Replacement by the module wizard switch of XG5000
Refer to how to use the module change wizard of XG5000
Notes
1) When FEnet I/F module is replaced, reset the opposite side device (MMI or PC).
The device
may stop communicating due to the time out of the applicable module