Chapter 6 High-speed Link Service
6-17
6.6.2 In case of single network
In case of single network, A-Side and B-Side are in the same network so station number and IP
address should be different.
[Fig 6.6.2] Single network configuration
(1) In case XGR is transmission mode and XGK(I) is reception mode
1) Data TRX
In case of transmission, since station to receive is only one, communication setting is
same with that of XGK(I)-XGK(I). In the reception side, when FLAG is ON, receive the
data of A-Side and when FLAG is OFF, receive the data of B-Side
(2) In case XGK(I) is transmission mode and XGR is reception mode
1) Data TRX
Make the XGK(I) send the same data to two communication module. In the reception
side, take the data entering to Master as input data and use STATE FLAG as input
condition of SYNC instruction to copy the Standby data to Master
To Next Page
Loading...