Chapter 5 XG5000 Program
5-3
There are 4 types of PLC series; XGK, XGB, XGI and XGR. For more detail, refer to relevant user
manual. Here XGK is selected as example. There are 5 CPUs in XGK; XGK-CPUU, XGK-CPUA,
XGK-CPUE and XGK-CPUS.
After setting is complete, menu of [Fig 5.2.3] will be displayed.
[Fig 5.2.3] Initial menu of XG5000
5.2.2 Register of communication module
Here describes standard setting that is necessary to execute FEnet module
(1) Selection and execution of communication module
For standard setting of communication module, register the communication module at
relevant base, slot. The user can register in on-line or off-line status.
A) Register in off-line status
If you register a communication module without connected to XGT, Use a āCommunication
module settingā window.
If FEnet is to be registered on base 0 and slot 2, Set it in the following procedure at a project
Window.
To Next Page
Loading...