Chapter 6 High-speed Link Service
6-20
The user can set SEQ-NO and user data in one block like the figure below
[Fig 6.7.7] HS link parameter setting not including sequence reception
c) HS link block setting ( Comm. module connected to XGR B-Side)
[Fig 6.7.8] HS link parameter setting including sequence reception
The user can set SEQ-NO and user data in one block like the figure below
[Fig 6.7.9] HS link parameter setting not including sequence reception
4) Ladder program (XGK(I) reception side)
a) Setting the input data by using HS_FB Function Block
[Fig 6.7.10] Function Block for redundant HS link reception data
To Next Page
Loading...