Chapter 6 High-speed Link Service
6-24
3) Comm. setting (XGR reception side)
a) Standard parameter setting
[Fig 6.7.15] redundant reception side standard setting
b) Block setting
[Fig 6.7.16] Redundant HS link reception parameter setting
4) Ladder program (XGR reception side)
In case network is normal, the user can take data of Master side but in case network is
not normal, the user copy the data of Standby to Master and take it as input data by
using STATE FLAG and SYNC instruction. At this time, user should set all reception
block of both A/B-Side so use STATE FLAG not _HSx_LTRBL as a condition to check
network status
[Fig 6.7.17] Ladder program through SYNC instruction
To Next Page
Loading...