Chapter 7 P2P Service
7-25
2) Writing message
Press “Message” to edit message
[Fig 7.6.9] P2P project window (Message setting)
The following figure is message edit window
[Fig 7.6.10] E-mail message registration window
Click “Add” to activate the following screen. Set the Form and Size and write the message data.
Form is classified into String and Byte data receiving from CPU. Form MB is used to send
as many message data of P2P ESend parameter as byte set in Size
“Change” is used to change the line when outputting data at the received screen.
To Next Page
Loading...