LSIS XGL-EFMTB - P2 P service at Redundant System

Chapter 3 Installation and Operation
3-7
[Figure 3.2.4] System configuration example using XGL-EH5T
(1) Installation of cable
XGL-EH5T uses UTP cable that is same one used in XGL-EFMT. For more detail, refer to 3.2.1.
This switch module provides Auto Cross Over function so the user can use both cross and direct
cable.
Redundancy PLC
Open Network (Ethernet)
GMR
GM1/2/3
GM4C
GM4
GMR/1/2/3,
K1000S
XGK
-CPUH/S
XGI-CPUH
Ethernet between PLCs
Engineering
Workstation
PC Card