Chapter 6 High-speed Link Service
6-2
6.2 High-speed Link Send/Receive Data Processing
High-speed link application will be described below with the example where FEnet I/F modules of the
stations No.0 and No.1 are to send and receive the data between each other.
The station No.0 transmits the data of 10 words from M0000 to M0009 with block No.0 and the
received data, transmitted by the station No.1, is saved on M0010. The station No.1 receives data of
10 words from the station No.0 to save on M0030, and transmits the data of 10 words from M0020 to
M0029 word with block No.1.
There are 32 blocks for Send data and 64 blocks for Rx data in the High-speed link parameters. The
block number can be set 0~31 for transmission or 0~63 for receiving. The Send side needs only to
decide which data to read and which block number to send to without setting the destination station No.
when transmitting the data is setup.
[Table 6.2.1] Diagram of High-speed link processing blocks
To Next Page
Loading...