LSIS XGL-EFMTB - Page 91

Chapter 6 High-speed Link Service
6-9
(4) HS Link Block Settings
Double-click the left mouse button on the ‘HS Link Block Settings window’ to open [Fig.6.4.6]
screen to register HS link blocks.
[Fig. 6.4.6] HS Link Block Settings
Classification
Description
Station type Master
FEnet I/F module operates as master. Slave function is not
supported.
Mode
Send
Transmits data.
Receive
Receives data.
Station
number
Native/
Destination
Station No
Automatically, The High-speed link station number of self-
station will be setup for Send blocks. Setup the High-speed
link station number of correspondent station for Receive blocks.
Available station No. for High-speed link with FEnet I/F module
is ‘0~63’.
Duplicated number is not allowed for station numbers of FEnet
I/F modules included in the identical network since it is a
specific number to discrim
inate FEnet I/F modules in the
network system.
Classification
Description
Block No.
Block number
Used to specify Send/Receive blocks.
Read area Address
The data memory address where the data to be transmitted is
stored.
Available memory area
1) XGK: P, M, K, F, T, C, U, Z, L, N, D, R, ZR
2) XGI/XGR: I, Q, M, L, K, U, R, W, F
Refer to the list of XGT CPU memory device in appendix for
available range of each memory area.
Read area
Word size
Size (Word) The size of data to be transmitted in word unit.
Save area Address
The data memory address to save the received data which is
transmitted by the destination station.
1) XGK: P, M, K, F(subsection), T, C, U, Z, L, N, D, R, ZR
2) XGI/XGR: I, Q, M, L, K, U, R, W, F(subsection)
Refer to the list of XGT CPU memory device in appendix for
available range of each memory area.
Save area
Word size
Size (Word) The data size of received block in word unit
[Table 6.4.3] High-speed link settings