Chapter 6 High-speed Link Service
6-12
[Fig. 6.5.1] Variable monitor window
(1) Run-link (_HSxRLINK)
As the whole information it shows if High-speed link is normally executed through the user
defined parameters, whose status will be kept ‘On’ if once ‘On’ until Link Enable is ‘Off’, and also
will be ‘On’ under the conditions specified below.
A) If Link Enable is ‘On’.
B) If all the register list settings of parameters are specified normally.
C) If all the data applicable to the parameters register list is transmitted and received as
specified in the period.
D) If the status of all the destination stations specified in the parameters is Run and with no
error at the same time.
(2) Link-trouble (_HSxLTRBL where x is HS link No.(1~12))
As the whole information it shows if High-speed link is normally executed through the user
defined parameters, which will be turned ‘On’ if condition to be turned ‘On’ the Run-link flag is
violated when Run-link is On, and will be turned Off if the condition is recovered.
(3) Tx/Rx status (_HSxTRX[0..127] where x is HS link No.(1~12))
As individual information it shows the operation status of High-speed link parameters on the
register list up to 128 registered items’ Tx/Rx information. If the Tx/Rx operation of the registered
items is agreeable to the Tx/Rx period, the applicable bit will be turned On, and if not, it will be
turned Off.
To Next Page
Loading...