Lumibird Quantel ABSOLU - BLOCK DIAGRAM

70 pages

Save Page as PDF

To Next Page

To Previous Page

Service manual

Service Manual – 9 / 63

XE_ABS_MT_AN_200224

6. BLOCK DIAGRAM

Superior part

Inferior part

Main Page

Table of Contents5
Introduction8
User Manual Terms and Safety Symbols8
Warnings & Cautions8
Servicing the Unit Warning & Cautions8
Using the Unit: Warnings and Cautions9
Probes: Warnings and Cautions10
Precautions to Take Concerning Wastes and Elimination of Device and Accessories11
Absolu Technical Specifications12
Classification12
Electrical Requirements12
Compliance12
Dimensions13
Environmental Conditions13
ABSOLU Computer System Specifications13
Ultrasound System Probes Specifications14
Standardized a Probe14
Biometry Probe14
15 MHZ B-SCAN Probe14
20 MHZ Annular B-SCAN Probe (Option)15
50 MHZ Linear Probe15
Block Diagram16
Main Unit and Accessories17
Main Units, Probes and Options17
Accessories and Consumables18
Spare Parts18
Footswitch19
Disassembling the Unit to Replace Defective Spare Parts20
Removing the20
Accessing Subsystem Boards20
Replace the A-15-50 ERM Board with a S-15-50 ERM Board21
Remove the Screen from the Base of the Device22
Open the Screen23
ABSOLU DEVICE DISPLAY - Adjust Magnifier Tool26
Probes Management and Calibration27
Standardized (A-Std) / Regular Biometry (A) Probe27
Adding or Removing a Standardized / Regular Biometry Probe & Calibration27
Delete or Add a New Standardized or Regular Biometry Probe27
Tissue Sensitivity Determination for A-Std Type of Probe (Only When S Mode Is Activated)28
Measurement Test Regular Biometry Probe Calibration29
Measurement Test Regular Biometry Probe Calibration32
Adding / Suppressing Other Probes (B15, B20-5A and Lin50Mhz)33
Linear Probe Calibration Check34
Calibration Tool34
Calibration Setup34
Calibration Procedure35
Check the Image of the Rings (Only B20-5A)37
Solving Noise Problems (with B and Linear Probes in Acquisition Mode)39
Probes Care40
Database Management41
Data Information41
Saving the Database41
Procedure to Save Only the Database (Without Data)41
Procedure to Save Only Data: Images, Cineloop42
Procedure to Save All Data (Database + Data: Images, Cineloop42
Database Factory Installation42
Procedure to Install the Database Factory43
Calibration of the "A-Bio" and "A-Probeam" Probes47
Transfer Database from Master Absolu to Destination Absolu47
Backup of the Master Absolu47
Install the Master Absolu Database in the Destination Absolu Software48
Calibration of the "A-Bio" and "A-Probeam" Probes52
Update Software53
Procedure to Install the New Software53
Upgrade of the Intel Graphics Driver55
Checking of the Intel HD Graphics 520 Driver Version55
Installation of the Recommended Driver Version56
Suspend Automatic Update59
Installation of Cobian Application60
Absolu Setup64
Retina Slope Test64
Contact Us Message65
Activate Threshold Line for LESION Q-I65
Activate Axial Length66
Hipaa Compliance67
Security Awareness and Training67
Contingency Plan68
Access Control68
Audit Controls69
Integrity69
Person of Entity Authentication69
Transmission Security70

Lumibird Quantel ABSOLU - BLOCK DIAGRAM

Table of Contents