Need help?Do you have a question about the M7 OMPHOBBY and is the answer not in the manual?
Details assembly of the main rotor hub, blade grips, and head components.
Covers swashplate driver arm, joint assembly, and final installation.
Guides assembly of the swashplate and control linkages for the helicopter.
Details assembly of the central dome, side panels, and servo mounts.
Covers installation of ESC plate, flight controller mount, and boom clamps.
Details canopy mount assembly and tensioner idler pulley system.
Guides the assembly of the belt tensioner mechanism, including knob and threaded pin.
Details main pulley, gear assembly, motor installation, and counterbearings.
Guides installation of the main drive gear, shaft, and pulley into the transmission.
Details assembly of the tail rotor head, hub, and blade grips.
Covers tail assembly, including belt idler, pitch slider, and bellcrank.
Details tail gearbox assembly and installation onto the tail boom.
Covers installation of the tail rotor assembly and pitch slider.
Guides attaching the tail boom, belt installation, and tensioning procedures.
Details servo assembly, mounting, and installation onto the frame.
Details assembly of lower/upper aux plates and battery quick release.
Covers lower frame panels, and tensioner screw installation.
Covers installation of the 3rd main shaft bearing block and tail rotor servo.
Details the step-by-step procedure for correctly tensioning the drive belt.
Covers the installation of the helicopter's landing gear.
Details motor installation, mounting, and securing with proper backlash.
Guides the installation of the vertical tail fin.
Details the assembly of the tail control rod with carbon tube and ends.
Explains installation and alignment of the tail control rod guides.
Covers swashplate installation onto the main rotor.
Details swashplate guide and main rotor head installation.
Covers main rotor installation and connection of linkage rods.
Guides the installation of main and tail rotor blades.
Explains how to install the battery using the tray and straps.
Details the installation of the ESC and flight controller unit.
Guides the process of attaching the canopy to the helicopter frame.
Lists accessories and provides recommendations for collective pitch and rotor speed.
Illustrates the recommended placement for various stickers on the helicopter.
Provides a catalog of accessory models OSHM7001-OSHM7012, detailing included parts.
To Next Page
General