214328 20 Revision A
Figure 3.8: Reel Left Arm
18. Lift reel and remove pins from endsheet and reel arm.
19. Align reel lift cylinder mounting holes until they line up
with lug on endsheet and hole in reel arm.
20. Secure cylinder to endsheet and reel arm with clevis
pins (A) and (B) as shown.
• Insert cotter pin into clevis pin (A) at OUTBOARD
side of reel arm
• Insert cotter pin into clevis pin (B) at INBOARD side
of endsheet
Figure 3.9: Reel Center Arm Shipping Support
21. Double reel: Remove remaining bolt (A), disengage
center reel arm shipping support (B) from cutterbar,
and remove shipping support.
ASSEMBLING HEADER
To Next Page
Loading...
