MAINTENANCE/SERVICE
Form # 169017 116 Issue – June 2008
7.8.3 GSL Adjustments
7.8.3.1 GSL Lateral Movement
The GSL should easily move into the N-
DETENT by itself. Adjust the lateral pivot
resistance as follows:
DANGER
Stop engine and remove key from ignition
before leaving operator's seat for any
reason. A child or even a pet could engage
an idling machine.
a. Remove the five screws (A) securing control
panel (B) to console, remove panel and store in
the tray.
b. Back-off the jam nut (C) and turn nut (D) to
either tighten or loosen the pivot. The nut
should be tightened to snug and then backed off
½ turn.
c. Tighten jam nut (C).
d. Check movement of GSL.
e. Reinstall the control panel (B) with the five
screws (A).
7.8.3.2 GSL Fore-Aft Movement
The GSL should remain as positioned by the
operator and yet can be moved without
excessive force. The spring is set at the factory
to 1.25 in. (32 mm) shown on the illustration.
Adjust as follows:
a. Move the console fully forward to ease
accessibility from the underside of the console.
b. To increase the pivot resistance, turn the nut (E)
clockwise to compress the spring.
c. To decrease the resistance, turn the nut (E)
counterclockwise to release the spring tension.
E
1.25 in. (32 mm)
D
C
B
A
To Next Page
Loading...
